Modified Płaczkowski Clamp for Dwarf II

This is a remix/tweaking of Andrzej Płaczkowski's EXCELLENT clamp to repair/reinforce the base on the Dwarf II telescope. If you didn't know, the early production runs had a weakness that allowed the bottom/center part of the base (which is where a tripod screws in) to detach from the rest of the telescope.

You will need two M4 bolts, about 20mm long; two M4 nuts; and I'd recommend four washers as well. You could probably get by with M3 hardware if you needed to. My apologies, you'll probably have to ream out the bolt holes a little with a screwdriver or bolt or something.

I printed these in PLA, 15% infill, 0.15 layer height. Only the Manfrotto piece needs supports. These settings seem to work fine, but I am always open to suggestions!

You will need one of the following groups of STL files to make a complete clamp:
A) The 0MLV6BA7bV0.stl file AND the Right Manfrotto Płaczkowski Clamp Dwarf II.stl file; or,
B) The 0MLV6BA7bV0.stl file AND the Right Arca Swiss Płaczkowski Cla