Thingiverse
ModMic Holder (Mic Part)
di MisterIXI
0
Download
1
Likes
0
Makes
Very basic clip for the modmic Microphone.
I only did a few iterations that it feels good enough. I wanted to not glue the magnet in place since that was the first thing failing on the original.
The cross is intentionally too thin to print well, it just needs to keep the magnet from falling out.
If I iterate further on the design I will update the file here.
(The original magnet or a similar one is obviously required, but nothing else)
I only did a few iterations that it feels good enough. I wanted to not glue the magnet in place since that was the first thing failing on the original.
The cross is intentionally too thin to print well, it just needs to keep the magnet from falling out.
If I iterate further on the design I will update the file here.
(The original magnet or a similar one is obviously required, but nothing else)
MisterIXI pubblica anche su
4 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
