Modualr Vallejo Paint Shelf

This is a shelf for my Vallejo 17mm bottles as well as my reaper masters paint.

I wasn't a fan of most of the shelves that I was finding. They were either too long to print or too large for my printer. So I made this very basic modular system that works for me.

It is modular in the sense that you can decide how long the shelves are to fit your needs by adding on my "middle" pieces.

I didn't take into account tolerances, so the tabs are an "exact" fit. Thankfully with my printer I was able to sort of snap the pieces together with out much issue. I applied superglue to the tabs then placed together. I also just super glued the brackets onto the bottom of the shelves. It seems that one bracket placed in the center of the shelf is enough to hold. Each piece takes just about 2 hours to print. I print four brackets at a time and it is just about 2 hours.