Modular Army Painter Holder

Yet another Army Painter paint holder. This system is designed to let you print as many holders as you need and snap them together. There is nothing fancy to them.

Motivation: The other modular systems are complicated and the non-modular systems just take too much time to print and would have to be modified to fit the count of bottles I have; so, I figured I could take a second and design something "better"-ish. Your own design is always the best design, right? ...yeah :)

These are stacks of three (each column has a 3 count) with a female connector on the left and male connector on the right. Each module simply drops in place. They provide a level of rigidity that allows you to pick a few up without them bending or falling apart and they can easily be slid around a desk.

I printed with supports for the female side. It just barely needs them to have a nice clean point of entry. The support should pop right off with your fingernail, no problem.