Thingiverse
Modular Bender Head
von xbost
237
Downloads
198
Likes
5
Makes
A Bender head. Planned to house a Raspberry Pi (or other SoC) inside. No mounts for the board yet.
Please note, it's a work-in-progress, and only been test-printed at 50% scale (about 100mm height without antenna, shown in the photo), parts' fit might be off in places at different sizes.
Supports needed for head shell and eyes.
Current issues:
* Clips holding the visor to the head are a bit weak and can snap easily, need to be reworked. Not an issue if you glue the whole thing together.
* Eyes have holes for pupils. Still undecided if pupils should be separate or attached to the eye mounting plate.
123Design original file is included.
Please note, it's a work-in-progress, and only been test-printed at 50% scale (about 100mm height without antenna, shown in the photo), parts' fit might be off in places at different sizes.
Supports needed for head shell and eyes.
Current issues:
* Clips holding the visor to the head are a bit weak and can snap easily, need to be reworked. Not an issue if you glue the whole thing together.
* Eyes have holes for pupils. Still undecided if pupils should be separate or attached to the eye mounting plate.
123Design original file is included.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
