MODULAR BRICK SECTIONS 1:87 HO SCALE

These MODULAR BRICK SECTIONS can be combined to make a variety of different buildings, both as fully 3D models and as background flats. I strongly recommend using a BRIM or RAFT when printing the tall column and spire roof. A BRIM and a RAFT essentially serve the same purpose for good stability when printing. A BRIM lays down a layer attached to the model and a RAFT lays down a layer and then starts the model on top of the raft. I will continue to add different modules in the future.

I exclusively print with PLA and have found that ordinary clear Klean-Strip lacquer thinner is a wonderful glue. Make a small test for yourself of two flat pieces of scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on styrene and PLA for years. No sloppy or messy glue to show when finished. For heavier construction use Testors "CEMENT FOR PLASTIC MODELS".

I have always pain