Thingiverse
Modular Copic Ciao Storage (Economic)
von PaulStar
120
Downloads
106
Likes
1
Makes
This is a modular, stackable storage designed for 6 Copic Ciao alcohol markers.
- Multiple storages can be combined next to each other with a simple click mechanism
- There are 2 ways to stack the storages
- Very stable
- Optimized for 3D printing
- Faster print time (-1h)
- Less filament needed (-28%), only 41g!
My goal was to use the advantage of 3D printing and optimize the design, so no supports are needed.
Another thing I focused on was to save filament and printing time. In comparison to my first solid version I reduced the printing time from 7:36 to 6:36. The filament consumption was reduced from 57g to 41g.
I recommend to apply adhesive rubber pads at the bottom I you have less than 4 or 5 full storages.
And last but not least. If anyone needs a different version for other Copic's or other brands feel free to contact me.
- Multiple storages can be combined next to each other with a simple click mechanism
- There are 2 ways to stack the storages
- Very stable
- Optimized for 3D printing
- Faster print time (-1h)
- Less filament needed (-28%), only 41g!
My goal was to use the advantage of 3D printing and optimize the design, so no supports are needed.
Another thing I focused on was to save filament and printing time. In comparison to my first solid version I reduced the printing time from 7:36 to 6:36. The filament consumption was reduced from 57g to 41g.
I recommend to apply adhesive rubber pads at the bottom I you have less than 4 or 5 full storages.
And last but not least. If anyone needs a different version for other Copic's or other brands feel free to contact me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
