Modular Customisable Cup Holder Adapter

Get the perfect fit for your car and drink bottle with this Modular Customizable Cup Holder Adapter Prints in two parts to avoid the need for supports or a tapered middle transition section Choose offset or centred alignment Round or square shaped holder Two styles of bottom section: full or minimal filament saver Optional lid for bottom section just for fun Got a new drink bottle? You only need print the top section Customizing There are two parts to the model, the upper part, the Holder - for your cup/drink bottle the lower part, the Insert - for fitting into the car's cup holder for the Holder use the inside dimensions - measure the size of the water bottle you want to fit for the Insert use the outside dimensions - measure the car's cup holder the Holder base diameter should be at least 2mm (ideally 3mm) larger than the Insert top diameter to avoid walls that are too thin where the parts connect if you choose the lid option two sets of mounting holes are added to the holder to ensure the best orientation for left-hand drive and right-hand drive cars it's up to you to use sane dimensions - there aren't many checks for weird combinations, like a Holder that is smaller the Insert :P when generating the model be patient, it can take some seconds to complete - computing the rounded edges is expensive. the Holder can be centred on the Insert or offset so one side is more or less flush with the insert The Holder can optionally include one or two handle slots. A single handle slot can either be on the “left” or “right” side of the Holder. The notion of Left and Right sides only matters when the Holder is offset. For a centred holder you can simply turn it 180 degrees. See the picture - the offset points to the front of the vehicle. Printing The model downloads from the Customiser as a single body. In the slicer choose “split to objects” to be able to apply different print settings for each piece. (And to delete unwanted parts if, for example, you already had the Insert