Thingiverse
Modular Desk / Wall Organizer
por Slimicus
7
Descargas
1
Likes
0
Makes
This is a modular desk / wall organizer I made. Each piece slides together with a very firm tolerance. Depending on your print settings this can be made looser or tighter, the top clips I left a bit loose.
It's designed to be expandable, currently I have trays that are multiples of 2.4" by 4", this gives a 3x5 grid that forms a 1 foot square area. These print very strong, and the largest of the boxes only takes about 2.5 hours, the 1x1 box takes about 2 hours.
There are mounting points on all sides, and these can be remixed easily to make wall mounts or adapters for the edges for things such as tool holders, pencil holders, or other utility components. (I will add them as I make them)
If the holes on the bottom are an issue, I'll add a cover if requested that's just a flat piece to cap off the bottom. Let me know in the comments.
Read the print settings carefully, I printed these without supports :)
-Initial Layer Height (layer 0) = 0.18
-Line width = 0.4
-Supports wil
It's designed to be expandable, currently I have trays that are multiples of 2.4" by 4", this gives a 3x5 grid that forms a 1 foot square area. These print very strong, and the largest of the boxes only takes about 2.5 hours, the 1x1 box takes about 2 hours.
There are mounting points on all sides, and these can be remixed easily to make wall mounts or adapters for the edges for things such as tool holders, pencil holders, or other utility components. (I will add them as I make them)
If the holes on the bottom are an issue, I'll add a cover if requested that's just a flat piece to cap off the bottom. Let me know in the comments.
Read the print settings carefully, I printed these without supports :)
-Initial Layer Height (layer 0) = 0.18
-Line width = 0.4
-Supports wil
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
