Modular Drawer system for computer desks

Layer height: 0.2mmSupport: only for the case if you print the hollow oneA simple drawer system to expand the storage on my L-Shaped Computer desk, which has a small, elevated shelf. It´s my first design project and I really hope you´ll like it.The “Drawer table clamp” you will need 4x for a shelf with a width of 170mm and a thickness of 12mm. It clamps the whole system to the shelf for stability as seen in the first picture. If your shelf or desk is a different size, I added a pic of the sketch so you can make it fit to your table.The System is stackable with the “c-clamps”. Just add another case on top and connect the two with 4 c-clamps. These will fit sideways too if you want to connect the drawers next to each other.Lastly, the drawers are designed to be printed in “Vase mode” (or “spiralize outer contour” in Cura slicer). I recommend you set it to at least 2 bottom layers for good stability. Remixes are welcome, to expand the range of fitting desks, or smaller/larger Versions to