Modular Dremel tool holder

Yet another one !

Based on 6 tool wide, dovetail linked small modules, this system offers à wide variety of combinations. Can be disassembled and reorganized easily.

The front and rear of the blocks can receive containers (04,05,06,08,09) to store shankless tools.

Blocks to store drill bits (10,11,12) are also available.

Special bloc for holding 4mm hex screwdriver bits (20) is also present, they can be added 2 hooks (21,22) holding Es120 type screwdriver.

### Assembly, Disassembly ###

Pieces are originally made for 350µ layers, dovetail tolerances are tight, once assembled they will not be easy to disassemble. To dismount easily use the edge of a table like shown on the image. Don’t hesitate to use a rubber hammer if necessary. Pay special attention not to slant pieces while inserting or removing them.
If you print pieces with lower layer thickness they will be easier to manipulate.

Edge cups (04,05,06,08,09) have male dovetails so they can only fit to one sid