Thingiverse
Modular Eurorack 32 HP
von momarortotinon
272
Downloads
174
Likes
4
Makes
A very simple Eurorack that is modular. The rails is a copy of the ones used in Doepfer cases.
To get some stability, use a 4 mm threaded rod as shown in the pictures.
The rack is not the most sturdy one but functions well enough for simple modules when needed.
Instructions:
1. Print one side.
2. Print the other side.
3. Print 4 items of the 16HP rails (can be done in the same print).
4. Connect the parts with a 4 mm threaded rod. (use saw to adjust the length of the rod)
To get some stability, use a 4 mm threaded rod as shown in the pictures.
The rack is not the most sturdy one but functions well enough for simple modules when needed.
Instructions:
1. Print one side.
2. Print the other side.
3. Print 4 items of the 16HP rails (can be done in the same print).
4. Connect the parts with a 4 mm threaded rod. (use saw to adjust the length of the rod)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
