Modular Filament Drawer System (Bambulab friendly)

Remix info:The original design did not fit in my stacked lack table setup and the design did not fit on my Bambulab P1P printbed, so i had to redesign the whole thing.I made it a total 38mm less wide en 4mm less high (i wanted it to be square).Because of this width difference the rails had to be lowered for there to be enough clearance.this also had a great effect on the position of the pvc pipes and the force put on the faceplate when pulling on the drawers.front and backplates are also redesigned to fit the new frames and to provide enough strength and stability.underneath is the original desciption with some adjustments in parts i used.IntroThis is a modular drawer for filament storage. Each unit can be stacked vertically and horizontally. The depth is determined by the size of drawer slides used. Check below for the list of fasteners and drawer slides that work with this design. The system uses two frame pieces attached to the drawer slides for the frame. For the drawer, it require