Modular Hydroponic Tower ---- Remixed Base and Top

Update: 07/03/2025I re-designed the top piece for better printability, to use less material, and hold a ½" piece of pvc in the middle. The redesign made the cone go up at more of an angle, the holes in the bottom are a little further apart. This allows better water flow as well as better printability. The cone is smaller in the middle as well as flat on top to make the water flow better. The redesign is Version 2. ------------------------------------------------------------------------------------------ I needed a few parts that I did not see yet. I wanted to be able to have a large tub with the towers sitting on a board next to each other with a PVC pipe feeding them all from the top. They will have a tee fitting and dived the flow to multiple towers.This allows that and maybe other uses. These are crude but do the job. I'm not the best making models so I did my best. The base will need supports under it just for the tabs with the holes for the screws. Use whatever supports yo