Thingiverse
Modular MK8/MK10 Extruder Unit
por amasraff
17
Descargas
18
Likes
0
Makes
Most MK8/MK10 based extruder unit share similar problem, the bigger part is a single piece and what if you screwed up ended up buying an extruder unit but the orientation were wrong?
The idea for this is to solve Left/Right hand orientation of the extruder unit by having them as a single piece that can be rotated according to your preference.
Lever has 2 versions:
- teflon - there will be a short teflon tube ran through the lever and act as substitute to the conventional bearing.
- bearing - conventional method of pushing the filament to the extruder gear.
They are not physically tested yet, virtually it should work as it should be.
The idea for this is to solve Left/Right hand orientation of the extruder unit by having them as a single piece that can be rotated according to your preference.
Lever has 2 versions:
- teflon - there will be a short teflon tube ran through the lever and act as substitute to the conventional bearing.
- bearing - conventional method of pushing the filament to the extruder gear.
They are not physically tested yet, virtually it should work as it should be.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
