Office
Go to Model
Modular Monitor Riser
5
Downloads
2
Likes
2
Makes
I wanted to try for a simple easy to print monitor riser that was strong without using a ton of filament. These take about 2 hours to print and use just a little under 100 grams of filament. They print with the legs pointed up and do not need supports or anything. Sorry for the bad pictures! I need a setup for just taking pictures of my models. You can also print two on one plate if you want more than one at a time. Using 12mm wooden dowels for the legs and 6mm wooden dowels for the bottom you can add a lot of strength. I actually had my 30lb kid stand on them once I had the dowels in and it held them just fine. If you wanted you could also use a threaded metal rod with a nut screwed to your required height, it would make it even stronger still adding a 6mm threaded rod to the bottom. I plan on adding to this model soon with longer leg versions and spacers. If you have any other ideas please let me know!!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
