Thingiverse
Modular not Lego Lightsaber
769
Download
722
Likes
4
Makes
This is definitely not a 12X scale modular Lego Lightsaber seen here: https://www.youtube.com/watch?v=QxVBF9aY2yo (the one in this video was a previous version that needed glue)
The parts are assembled without glue or hardware. All you will need is a mug of hot water (I'll explain).
The Hilt is made of 4 parts that all screw together and take 9h45 to print.
The Blade is printed in 2 parts, in vase mode with each half taking about 1 hour.
All parts are saved in the correct orientation for printing and are to be printed without supports (except for the bottom of the hilt).
Hilt build instructions:
>Print Hilt Top 1x
>Print Hilt Middle 2x
>Print Hild Bottom 1x
>Screw all the parts together
>Note: If the screw thread tolerances are too tight, simply dip each of the male ends of the screws into boiling water for 3 to 4 seconds and then try to screw them in for a perfect fit.
Blade build instructions:
Print Half Blade Twice in vase mode with 3 bottom layers and no top
The parts are assembled without glue or hardware. All you will need is a mug of hot water (I'll explain).
The Hilt is made of 4 parts that all screw together and take 9h45 to print.
The Blade is printed in 2 parts, in vase mode with each half taking about 1 hour.
All parts are saved in the correct orientation for printing and are to be printed without supports (except for the bottom of the hilt).
Hilt build instructions:
>Print Hilt Top 1x
>Print Hilt Middle 2x
>Print Hild Bottom 1x
>Screw all the parts together
>Note: If the screw thread tolerances are too tight, simply dip each of the male ends of the screws into boiling water for 3 to 4 seconds and then try to screw them in for a perfect fit.
Blade build instructions:
Print Half Blade Twice in vase mode with 3 bottom layers and no top
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
