Thingiverse
Modular Paint Stand
von GetMePrintin
23
Downloads
15
Likes
0
Makes
Designed this paint stand since I could not find any modular ones. Uses 5mm x 2mm magnets. Can hold brushes with a diameter of 1cm horizontally.
Holds 33mm (Citadel) and 25mm (Vallejo etc) bottles. Included the unedited structure piece so you can design your own if you like to
If you store mainly big bottles on there there is a structure element with a flat front, so you dont have the magnet holes visible there.
It is magnetized with to be fair a few too many magnetholes. I would suggest using half of them. 16 magnets per structure is ... alot. I will be revisting this project but doing it from ground up again, so no "WIP" here. Will be another post.
Will also not be compatible, since I noticed that the magnetholes are so close to eachother that the corners are a little sketchi to print.
Holds 33mm (Citadel) and 25mm (Vallejo etc) bottles. Included the unedited structure piece so you can design your own if you like to
If you store mainly big bottles on there there is a structure element with a flat front, so you dont have the magnet holes visible there.
It is magnetized with to be fair a few too many magnetholes. I would suggest using half of them. 16 magnets per structure is ... alot. I will be revisting this project but doing it from ground up again, so no "WIP" here. Will be another post.
Will also not be compatible, since I noticed that the magnetholes are so close to eachother that the corners are a little sketchi to print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
