Modular Plant Support

Modular multipart plant support. You can stack as many extension parts as needed. Parts will snap together tightly by pushing them together. May need some force to assemble but has rigid connection. The fit is quite precise so calibrating your filament is recommended. If the connection feels too tight, before forcing it (could crack), please check the supported area of the connector that the surface is clean of support material. If not, finalize with knife etc. The ties will also lock to the slots in sticks by pulling through. I have tested this with Bambu PETG HF, Bambu PLA basic and Sunlu PLA+ 2.0. All have worked well but at least for outside use PETG is recommended. In the print profile plate 1 has a starter kit and other plates are for individual parts to print as needed. Added 2nd variant with stronger connection. Both variants are compatible with each other. Only difference is slightly wider ends and the connector hole is slightly larger in variant 2 for easier connect. With the