Thingiverse
modular spool storage shelf/stand
door da_syggy
217
Downloads
190
Likes
4
Makes
**Spool stand/shelf for 20cm spools**
I had my filament spools stored in a drawer, laying on their side and on top of each other. I always had to take out 2 or 3 spools to get the one I needed.So I designed a simple, modular and interlocking lightweight stand to store the spools in upright position.
They are ~7cm wide and fit one spool with a few mm of wiggle room.
I printed them in rough draft mode at 0.24mm layer height to save time, for better finish I recommend 0.16 or 0.2mm
These can of course be used on every flat surface, e.g. an existing shelf.
I had my filament spools stored in a drawer, laying on their side and on top of each other. I always had to take out 2 or 3 spools to get the one I needed.So I designed a simple, modular and interlocking lightweight stand to store the spools in upright position.
They are ~7cm wide and fit one spool with a few mm of wiggle room.
I printed them in rough draft mode at 0.24mm layer height to save time, for better finish I recommend 0.16 or 0.2mm
These can of course be used on every flat surface, e.g. an existing shelf.
da_syggy publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
