Modular Windmill Turbine - No Hardware required

V5 Is finally here!Assembly tips:DO NOT use a hammer or excessive force. This will cause the parts to shatter.Instead, apply an even pressure using a vice or a clamp.If the parts still do not wish to budge, then please the male connector in the freezer, and the female connector in some warm water.Print in petg, abs or asa, not pla. Pla is too brittle and will snap. MembershipLike what you see, want to commercially sell physical prints of this model? To obtain a commercial license, please check the available options. This is the most recent edition of my fully printable wind turbines. After many months of design, testing and iterating; I have finally completed version 5. The biggest difference between this version and any of my previous ones is the fact that the design is now modular, this means you can make bigger better wind turbines with your standard printer. I plan to introduce more parts to allow you to customise every part of the design to your liking, and if there isn't a pa