Thingiverse
Electronics
Zum Modell
Modular WS2812 Neopixel stack light andon
24
Downloads
43
Likes
0
Makes
Modular design approach to a stackable andon light using commonly available flexible WS2812 (or similar) LED strips. LED spacing is 16 mm.
Module diameter is ~50 mm and height is ~
I made this design a while ago but didn't think it was ready enough for uploading.
There are some tight tolerances especially in the LED strip holders making up the center pillar everything rests on. A better approach may be to simply use a PCB with similar dimensions instead of fiddling the LED strips into a long center pillar.
To save a lot of time and retracts, print the diffusers with 0 % infill. The walls are so thin, that no infill is actually necessary.
One method to drive the LEDs is with WLED, by grouping the LEDs accordingly into lighting segments.
Module diameter is ~50 mm and height is ~
I made this design a while ago but didn't think it was ready enough for uploading.
There are some tight tolerances especially in the LED strip holders making up the center pillar everything rests on. A better approach may be to simply use a PCB with similar dimensions instead of fiddling the LED strips into a long center pillar.
To save a lot of time and retracts, print the diffusers with 0 % infill. The walls are so thin, that no infill is actually necessary.
One method to drive the LEDs is with WLED, by grouping the LEDs accordingly into lighting segments.
NilsR veröffentlicht auch auf
13 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
