Thingiverse
Modules with better alignment and lips for netpot
door Wolfire18
202
Downloads
135
Likes
1
Makes
02/11/2020: added a base module with 4 M5 screw holes. I just screw this module on a bucket lid, or even a wooden base on top of the bucket.
02/10/2020: added a resevoir module with a 3/4" BSP thread to attach a quick hose
connector for easy maintenance or modification of the whole tower
First of all all credits to Archipelagourbanfarms, with his desing.(https://www.thingiverse.com/thing:2403922)
I liked this desing soo much (and i printed it ofc). But i'm a damn perfectionist and seeing that the top was slightly off center with a step, it was bothering me.
So, i redesigned the module adding from 1 to 3 slots, even with a lip to hold the net cup once the plant/s is/are quite big (as seen here: https://www.thingiverse.com/make:450646).
Note: if you plan to print the modules with the lips, you should print them upside down, just to avoid any support.
hope you like them, good luck!
02/10/2020: added a resevoir module with a 3/4" BSP thread to attach a quick hose
connector for easy maintenance or modification of the whole tower
First of all all credits to Archipelagourbanfarms, with his desing.(https://www.thingiverse.com/thing:2403922)
I liked this desing soo much (and i printed it ofc). But i'm a damn perfectionist and seeing that the top was slightly off center with a step, it was bothering me.
So, i redesigned the module adding from 1 to 3 slots, even with a lip to hold the net cup once the plant/s is/are quite big (as seen here: https://www.thingiverse.com/make:450646).
Note: if you plan to print the modules with the lips, you should print them upside down, just to avoid any support.
hope you like them, good luck!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
