Mole trap (grab it alive)

This simple trap grab the mole alive so do not worry about it.

Print: all the parts must be align on the flat surface except the frame.
I aligned the frame on the outside. that need just a few support while printing.

- Screw 2 pieces of M5 nuts on the doors. This weights keep the door in closed position,
- Put 2x 3mm diameters x 28mm long of shaft in the frame to hold the door,
- insert the two assembled frames each end of the pipe glue it if needed. make sure the doors be parallel.
- When you use the hinge must be on top. The doors must be open and close easy.

Do not kill animals!