monarch dragon (king version)

This is the monarch dragon king version from my Monarch Dragon series. It's 100% print-in-place with no assembly required. Gyroid infill is recommended but not required; it's multicolor-friendly as long as you color it with a layer range. takes at least less than 1 hour and a half, with no small parts that could choke children and it's stronger than it seems no supports are required but you will still get the notification that require supports ignore this message please print the test print first at your selected scale if you cannot access the test print try making your own by cutting off some of the segments and printing them first it is safe to print it in sport. It was made in Tinkercad and is low-poly except for the linkages. Never scale down more than 20% doing so may result in fusing. A brim is required. An 8mm brim is recommended. It may be a little stiff at first, but it will loosen up after a while of flexing. Never flex too much on the first flex, first five comme