Monarch dragon (non Monarch version)

This is a fun and simple 3D printed Dragon made in Tinkercad, and it's PLA friendly with no small parts that would make children choke it is print in place with no support I would not recommend scaling down more than 15% but there is no limit for how much you can scale up and as you see in my pictures it is multicolor friendly during printing you may think that it is fragile but it is actually very strong I printed it in pla and for those people who are doing their first multicolor print using this if a box appears click on it and it will say Prime Tower if you see this Tower go into global others and turn off prime tower because it is not needed for this print and it wastes filament you can actually print it in sport if it tells you that needs supports either ignore that message or turn on supports in only critical regions after turning that on it should remove all supports it is low poly except for the chain links I will later post a king and queen version with the queen requirin