MakerWorld
Office
Go to Model
monitor arm
16
Downloads
11
Likes
2
Makes
I have the Samsung S22R35x, and the original stand was unnecessarily large and also too short for my liking.This model is made up of three main parts and four screw hole covers, which are optional and not required for use.The arm has been on my desk for more than a few months now, and it’s much better than the original stand. It is printed in PLA, and so far I haven’t noticed any material creep or deformation at all.It could probably fit other displays as well, but you’ll need to check the hole pattern on the back of your monitor to make sure it’s compatible.If you decide to print it, I’d really appreciate your feedback.Thank you!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
