Monitor Feet
von flatleyaia
2
Downloads
2
Likes
0
Makes
We needed to tilt our monitor back a bit. We used corks for awhile - but they're ugly! So we made these two little feet for the monitor stand. They look like squished spheres.
I printed with a 2 layer shell, 20% infill, at .2mm/layer height. No supports or adhesion necessary. Designed on Fusion360. Then I played with Meshmixer to smooth out the edges & created another version.
I printed with a 2 layer shell, 20% infill, at .2mm/layer height. No supports or adhesion necessary. Designed on Fusion360. Then I played with Meshmixer to smooth out the edges & created another version.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
