Monitor Lifter for Asus VP249

This is a quick-and-dirty foot for lifting an Asus monitor 5cm up
v3a is the recommended one. v3b was an attempt at using a solid design but letting the slicer remove the top so as to get a purely infill-controlled body. I abandoned the B version myself because the slicer acted up when I tried, Your mileage may vary :)

As you can see on the photo, mine was printed using .28mm layer height which results in rather visible layer lines that are okay in the setting where this one is used. Infill can be set quite low if there are enugh top layers to compensates (I used 3% infill and four top layers), but the top is covered by the monitor in any case