Thingiverse
Monitor Pen Holder
von Airoz
0
Downloads
0
Likes
0
Makes
This is a simple and practical monitor-mounted pen holder that hooks over the top edge of your monitor,
It is designed to work with monitors up to 17 mm thick and requires a flat back so the holder can sit flush against the monitor for proper fit and stability.
Compatibility Warning:
❗ Not suitable for curved monitors or monitors with angled/recessed backs, as the holder may not sit flush or securely.❗
This is my first post, and any feedback would be very much appreciated. I’m also relatively new to CAD, so my workflow in Fusion could definitely be improved.
Printing Notes (Tested Settings):
- Printer: H2S
- Material: PLA
- Infill: 9%
- Walls: 1
- Supports: ON
It is designed to work with monitors up to 17 mm thick and requires a flat back so the holder can sit flush against the monitor for proper fit and stability.
Compatibility Warning:
❗ Not suitable for curved monitors or monitors with angled/recessed backs, as the holder may not sit flush or securely.❗
This is my first post, and any feedback would be very much appreciated. I’m also relatively new to CAD, so my workflow in Fusion could definitely be improved.
Printing Notes (Tested Settings):
- Printer: H2S
- Material: PLA
- Infill: 9%
- Walls: 1
- Supports: ON
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
