MakerWorld
Office
Model downloaden
monitor table 28,1cm
1
Downloads
0
Likes
0
Makes
Bracket model designed for the Bambu Lab P1S printer. Board width: 28.1 cm. The parts connect via press-fit, but additional gluing is recommended for better stability. A cable hole is located at the center joint. The middle section is optional — it was added purely for visual purposes. Height from the table to the platform: 14 cm (with clearance). Total model width: 30 cm. The model consists of 2 parts optimized for printing on the P1S. It is recommended to attach felt pads on the back to allow the stand to rest properly on a desk mat.Boost Methank you very much for the boost
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!