Monitro Dragon

A slightly different approach to monitor models. This time I wanted to create a model that doesn’t hook from the back, but instead grips the corner of the monitor. It wasn’t an easy task, as models usually slide off the edge or fall when the desk is bumped. After several experiments, I managed to achieve the desired effect. It required many test prints, as shown in the photo below. Instructions: To make the model hold onto the edge, you need to match it to your monitor thickness. Measure the thickness with calipers and adjust the model size accordingly. The default paw spacing is 15 mm. You can do this using the Measure Tool [U] and Scale Tool [S]. You can also use the Measure Box. In the example below, the default X dimension is 15 mm. I increased it to 20 mm, which equals 133% scaling. You should scale the dragon by the same percentage so that the paw spacing becomes 20 mm. If adjusted correctly, the dragon will hold using only its lower paws, and the tail can hang freely in the air,