Thingiverse
Monkey Trophy Statue - Learning Award
24
Descargas
19
Likes
0
Makes
#Attribution
Remixed from Ratherwok, see the original monkey: [Original monkey](https://www.thingiverse.com/thing:1326728)
#Features
This remix adds a pillar and base that matches the block that the original monkey sits on.
#Printing
I used a raft for adhesion to print both main parts, but may not be necessary for the trophy base.
You should be able to get away with 10% infill for the base and 20% for the monkey.
#Assembly
The tail is just a length of filament like in the original, however is not a snug fit as the monkey is scaled up to 140% of the original. I used a hair dryer to curl the filament into the tail.
I recommend glue for putting the parts together, and I had to use blu-tac for the tail.
If you liked the design, please upload your make, otherwise I'd be grateful if you left a comment! It'd be nice to know if this design came in handy for anyone
Remixed from Ratherwok, see the original monkey: [Original monkey](https://www.thingiverse.com/thing:1326728)
#Features
This remix adds a pillar and base that matches the block that the original monkey sits on.
#Printing
I used a raft for adhesion to print both main parts, but may not be necessary for the trophy base.
You should be able to get away with 10% infill for the base and 20% for the monkey.
#Assembly
The tail is just a length of filament like in the original, however is not a snug fit as the monkey is scaled up to 140% of the original. I used a hair dryer to curl the filament into the tail.
I recommend glue for putting the parts together, and I had to use blu-tac for the tail.
If you liked the design, please upload your make, otherwise I'd be grateful if you left a comment! It'd be nice to know if this design came in handy for anyone
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
