Monoprice Mini Delta Limit Switch Mount

I replaced the controller board in my Monoprice Mini Delta with a [BIGTREETECH SKR PICO V1.0](https://www.amazon.com/gp/product/B09MYKL9MP/?tag=synack-20) and had some trouble getting the optical endstops to work. I designed this mount for some [Micro Limit Switches](https://www.amazon.com/gp/product/B07X142VGC) to replace the optical endstops. Note that you'll loose 10-20mm of Z travel depending on how compact you can make the switch wiring.

To make three of these, one for each axis, you'll need the following hardware:

6x 20mm M2.5 SHCS
6x M2.5 Hex Nut
6x 8mm M3 SHCS
6x M3 Washer
6x M3 Hex Nut

The M2.5 hardware goes through the switch body, while the M3 hardware mounts to the aluminum extrusion behind the belts.

You will likely need to remove the cap at the top of each axis to loosen the belt and replace the M3 hex bolt you lost when you removed the optical endstops.

1. Install the rear M2.5 hex bolt through the limit switch.
2. Put some heat shrink tubing on the w