Monoprice Mini Delta Riser Feet

The stock rubber pads for the MP Delta are only about 4mm tall. I wanted something a little taller for better airflow underneath especially if I add a fan in the base. These bolt up in existing holes. You could probably reuse existing screws, but I swapped in M3x8mm hex heads in place.

For the rubber feet I had some leftover 21mmx15mmx11.5mm tall feet with some M5x8mm screws and a square nut that slides into a holder in the foot. This adds about 21mm clearance for a whole inch below open area.

I also have a version with a couple of slots where you can zip tie up the power or USB cords to provide strain relief. With the power connector attached directly to the control board I was a little concerned about possibly damaging it if I drop the power adapter or something

I made this on my Anet A8 but they will fit on the delta itself also