Monoprice Mini Select PiCam Mount

This is a mount for raspberri picam that you install onto octoprint.

Note that all the parts are generic and can be used for other printers if you print the last part that connects to your printer.

Don't print the part that says DONOTPRINT - it's a diagram for assembly instructions.

This prints at 0.0875 or 0.175 layer heights. Generally the only part that you should print at 80% infill is the M8x15mm bolt. Others can be printed at 20% - or if you rally want them stiffer, use 1.2mm for wall width.