Thingiverse
Monoprice Select Mini V2 Handle
von gexgecko
7
Downloads
4
Likes
0
Makes
I am lazy and I did not want to have to buy new screws, so I designed this handle for the MPSMv2. It might fit a V1? I'm not sure.
Uses 3 of the stocks screws which hold the metal frame together.
You can print without supports, or add a couple to the very back of the handle curve.
(Pictured was without supports)
You will have to flex the back metal panel out slightly after the screws are removed (just using the slot on the left and your left hand) in order to hook the hook at the back. After that, the rest should snap on easily, and you can drive the screws back in.
Works a treat! Enjoy!
Uses 3 of the stocks screws which hold the metal frame together.
You can print without supports, or add a couple to the very back of the handle curve.
(Pictured was without supports)
You will have to flex the back metal panel out slightly after the screws are removed (just using the slot on the left and your left hand) in order to hook the hook at the back. After that, the rest should snap on easily, and you can drive the screws back in.
Works a treat! Enjoy!
gexgecko veröffentlicht auch auf
81 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
