Thingiverse
Monster Hunter Shelf Bracket
von llamas_m
2
Downloads
9
Likes
0
Makes
Hello everybody.
This is the first contribution I make on this page and I hope you like it. I bring you a shelf bracket inspired by the Monster Hunter franchise. To hang it on the wall I have used M5x30 wall screws with its corresponding plug and to anchor it to the wooden plank I have used m5x20 screws (The wooden plank that I have used is 2cm thick). If you need to make calculations, consider that the head of the screw remains approximately 1cm inside the piece.
Regarding the printing parameters, I have done it in PETG with 3 layers on each side and a 50% infill resulting in a very hard piece that supports the weight of what you put on it very well. Print it in one of the faces with the logo.
I hope you like it and tell me any questions or problems and if I can I will be happy to answer you.
This is the first contribution I make on this page and I hope you like it. I bring you a shelf bracket inspired by the Monster Hunter franchise. To hang it on the wall I have used M5x30 wall screws with its corresponding plug and to anchor it to the wooden plank I have used m5x20 screws (The wooden plank that I have used is 2cm thick). If you need to make calculations, consider that the head of the screw remains approximately 1cm inside the piece.
Regarding the printing parameters, I have done it in PETG with 3 layers on each side and a 50% infill resulting in a very hard piece that supports the weight of what you put on it very well. Print it in one of the faces with the logo.
I hope you like it and tell me any questions or problems and if I can I will be happy to answer you.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
