Slicer Discord
Monster LED remote holder – 3D printable model from MakerWorld MakerWorld
Electronics

Monster LED remote holder

13 Downloads
4 Likes
4 Makes
Go to Model
SummaryDollarama had these kits for $4, so I'm going to add them to my cabinet.This piece should give me a place to store the remote.May be very tight fit.Works great, but if you jam the remote in there tight it is hard to remove, good but also possibly bad.Sanding the inside or bumping up the print size by a percent or two is advised.
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Sanding
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

unhooked also publishes on

189 additional models across 2 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection