Thingiverse
Monster phone stand
por garethjpowell
5
Descargas
2
Likes
0
Makes
A rather large phone stand with a slot for mini/micro USB power for those phones with the connector at the bottom. Also has a slot going front to back for the USB power cord. Max phone width is 60mm for this item. Depth is ~20mm.
I'd strongly suggest printing with 9% honeycomb fill as it takes a while, being a large lump of a thing & you can hear the ABS creaking. The weight with this is enough to keep the phone stable.
If you want to be sneaky, print to about 50% height (before the USB notch gets expanded out as the phone base) then pause the printing while you fill the honeycomb chambers with some ball bearings or shot to give it some extra weight.
If you want to save material & printing time I'd suggest importing it into Blender & poking holes in it with the boolean tool.
I'd strongly suggest printing with 9% honeycomb fill as it takes a while, being a large lump of a thing & you can hear the ABS creaking. The weight with this is enough to keep the phone stable.
If you want to be sneaky, print to about 50% height (before the USB notch gets expanded out as the phone base) then pause the printing while you fill the honeycomb chambers with some ball bearings or shot to give it some extra weight.
If you want to save material & printing time I'd suggest importing it into Blender & poking holes in it with the boolean tool.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!