Monster Truck Big Rev

Get your motor running with Big Rev Monster Truck!   These should fit and roll down on Hot Wheels double tracks.   Our whole huge tribe of kids love these things, and they're decently durable and hold up even when using all PLA. This is the Big Rev Monster Truck version of the Monster Truck.   Here are some details that you should take note on:   Make sure your printer plate is clean and sticks well for builds.   Plate 1: Monster Truck Body: No supports or Brim are needed.   Plate 2: Rims & Axles: No supports or brim should be needed for either of these. I changed the rims to allow them to slide in and then be popped into place on the tire real nice. This also allows you to stick a small Phillips in the back end and pop the rims right off without issue.   Plate 3: Suspension: No supports or brim needed for these. These are the only thing I haven't modified yet.   Plate 4: Left and Right Side Tires: No supports or brim needed with these. The original only had one direction tread for all four wheels making one side point in one direction and the other side in the reverse direction. Now all 4 wheel tread will point in the same direction, only if you decide put them on the right way of course. You can print these in TPU but they work with PLA perfectly. Plate 5: Just a different variation and look from the original rims.   Plate 6: Is just the monster truck body with text added so you can easily change the text as you please.     How to build:   It's easy to build, but will require some finesse and a little patience and muscle.   Put both suspension pieces together flat side, and squeeze it into the rectangle hole under the monster truck while keeping both pieces as evenly together as possible, push the left side corner all the way in first, then bring the right side corner up in and apply a lot of pressure to pop them in. If you just cant get it in(that's what she said), then pull the left side back out, and try putting the right side in first and then popping the left