Thingiverse
Moon Ceiling Lamp
von everfordfoto
3
Downloads
11
Likes
0
Makes
Created a version that fits a "standard"(not sure if it's standard) 3 inch mount on a ceiling fan.
I used the 8inch version scaled up to 10in, because the 10 inch version printed too thin and had holes in the walls.
Created to replace the glass globe that would normally be there. Added a flange and hole to the north pole, also added a slight reinforcement at the joint using a modified tourus ring. I will be using LED bulbs in the light so heat shouldn't be an issue, but if it is should be easy to add vent holes to the top either manually with a drill or in CAD to the design.
7hr print on my Neptune 4
I used the 8inch version scaled up to 10in, because the 10 inch version printed too thin and had holes in the walls.
Created to replace the glass globe that would normally be there. Added a flange and hole to the north pole, also added a slight reinforcement at the joint using a modified tourus ring. I will be using LED bulbs in the light so heat shouldn't be an issue, but if it is should be easy to add vent holes to the top either manually with a drill or in CAD to the design.
7hr print on my Neptune 4
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!