Moon Lamp - Table Lamp Remix

I wanted a version of the moon light that didn't use 120v bulbs. I also wanted a traditional end table lamp format.

So I created this remix to use a cheap USB powered LED backlight kit from amazon. The LED kit was 6ft of LED strip, a remote control and an IR receiver/LED controller. The LED strip also came with adhesive backing, so it wrapped around the LED mount cylinder well. The kit only cost $8.

I took the existing moon holder piece from the source model and added 2 screw threads. Top screw thread for the LED mount cylinder and the bottom thread for the stand pipe cylinder.

Edit

Everything screws together very nicely. No supports are needed for anything except the base puck. You need supports for the channel in the base puck, but be sure to keep Cura from putting them in the threads, they aren't needed there.

I printed everything at 0.2mm in Enomaker ST-PLA (white and black) with 4 walls. 100% infill for everything except the base puck. The base puck was