Thingiverse
Moon Rover
by netpipe
4
Downloads
8
Likes
0
Makes
would like to make a herringbone version of this track.
unprinted the thickness was set to 0.8 so hopefully its enough if not just adjust the blend file. after trying to slice i can see this needs to be looked at closer. if need to print use original and vase mode.
checked for non manifold and overlapping faces, reextruded it not sure why it wont slice
https://woodgears.ca/bandsaw/crowned_pulleys.html was a suggestion from irc to center these better
https://www.thingiverse.com/thing:430305
https://www.thingiverse.com/thing:15528
https://www.thingiverse.com/thing:1936113
https://www.thingiverse.com/thing:3610134
unprinted the thickness was set to 0.8 so hopefully its enough if not just adjust the blend file. after trying to slice i can see this needs to be looked at closer. if need to print use original and vase mode.
checked for non manifold and overlapping faces, reextruded it not sure why it wont slice
https://woodgears.ca/bandsaw/crowned_pulleys.html was a suggestion from irc to center these better
https://www.thingiverse.com/thing:430305
https://www.thingiverse.com/thing:15528
https://www.thingiverse.com/thing:1936113
https://www.thingiverse.com/thing:3610134
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
