Slicer Discord
Moon Section 50 South-A – 3D printable model from Thingiverse Thingiverse

Moon Section 50 South-A

14 Downloads
8 Likes
0 Makes
Go to Model
The third in a series of three Moon sections from JAXA. Please load all three files to cover the Moon Latitudes from 80 South to 50 South, and half way around the Moon. They all fit together. Enjoy!
The Japan Aerospace Exploration Agency (JAXA) launched "KAGUYA (SELENE)" by the H-IIA Launch Vehicle at 10:31:01 a.m. on September 14, 2007 (JST) from Tanegashima Space Center (TNSC). The major objectives of the "KAGUYA" mission are to obtain scientific data of the lunar origin and evolution and to develop the technology for the future lunar exploration. "KAGUYA" consists of a main orbiting satellite at about 100km altitude and two small satellites (Relay Satellite and VRAD Satellite) in polar orbit. The orbiters will carry instruments for scientific investigation of the Moon, on the Moon, and from the Moon.
KAGUYA was descended to the 50km altitude from February 1, 2009 and then was descended again to 10-30km in Lower altitude (Perilune) from April 16, 2009. Finally, KAGUYA was impacte
Source
Thingiverse
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

4 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection