Thingiverse
MoonLight
por fake_tissues
155
Descargas
143
Likes
3
Makes
----
_MoonLight_
----
This nightlight or desk lamp is a model of our Moon's surface illuminated by a subterranean crown. Twisting the surface turns the light on and off.
----
_The most visible topographic feature is the giant far-side South Pole–Aitken basin, some 2,240 km (1,390 mi) in diameter, the largest crater on the Moon and the largest known crater in the Solar System._
----
_Supplies_
* All parts printed, 0.15 layer height suggested
* 4 x Bright white 5mm LEDs ([here](https://www.amazon.com/dp/B004UZCMRK/ref=cm_sw_su_dp))
* 1 x 9 Volt battery
* 1 x 200 Ohm resistor
* Wire or this [Electric Paint](http://www.amazon.com/Bare-Conductive-Electric-Paint-10ml/dp/B00B888LQ8) as I used. Very useful for building circuits on printed objects.
* Krazy Glue or Gorilla Glue (the only two I trust)
_MoonLight_
----
This nightlight or desk lamp is a model of our Moon's surface illuminated by a subterranean crown. Twisting the surface turns the light on and off.
----
_The most visible topographic feature is the giant far-side South Pole–Aitken basin, some 2,240 km (1,390 mi) in diameter, the largest crater on the Moon and the largest known crater in the Solar System._
----
_Supplies_
* All parts printed, 0.15 layer height suggested
* 4 x Bright white 5mm LEDs ([here](https://www.amazon.com/dp/B004UZCMRK/ref=cm_sw_su_dp))
* 1 x 9 Volt battery
* 1 x 200 Ohm resistor
* Wire or this [Electric Paint](http://www.amazon.com/Bare-Conductive-Electric-Paint-10ml/dp/B00B888LQ8) as I used. Very useful for building circuits on printed objects.
* Krazy Glue or Gorilla Glue (the only two I trust)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
