MoonSwatch Metal Case Conversion Ring & Spacer

I used this ring to install a genuine Moon Swatch movement (ETA G10.212) into an Aliexpress VK63 metal case.
Designed to be snug, so depending on your printers resolution, it may require very light sanding to fit. Notches go towards crystal side of case, long notch is to allow room for the pushers and the short notch is for the small nub at the 6oclock position of the movement.

When using the spacer ring between the dial and the case, this prints at 0.6mm. Drop both the spacer and the ring into the plate so that the spacer prints prints at 0.4mm and the ring prints at 1.5-1.6mm. The wide spacer is wider to hide the black marks on colored/white dials. The normal spacer is for black dials.

Video here: https://youtu.be/oOgDB119hXY
but mostly here: https://youtu.be/mw_eijouf5M

NOTE: I have just discovered that this does NOT work on any Moonphase MoonSwatches. Snoopy's, Earth Phase, etc. It's a thicker movement altogether and I'm currently developing a different ring for those models.