Mopar Gas Cap Plunger

This is a Gas plunger for Mopar Vehicles that use it. The little plastic piece on the gas cap allows it to lock in place / open when pressed. I made this since the OEM one broke on my mother's 2017 Chrysler Pacifica. I also tested it on my 2021 Ram 1500, and it is the same piece and worked fine. Based on Mopar (68524040AA) I printed it out of PETG since it will need to hold up around Gas. After printing, I would inspect the little overhangs and clean them up with a little knife. I also recommend pushing it in and out of the slot in the vehicle for a minute or two before attaching it to the gas cap to make sure no little pieces of support material make it stick closed. I included the step file if anyone needs to modify it further.