Thingiverse
Mosaic Z endstop support.
door alexanderhiam
3
Downloads
7
Likes
0
Makes
After about two months of owning a MakerGear Mosaic, I had only one small issue. The guide rod that the Z-endstop is attached to could rotate freely, causing the endstop switch to move out of place with the vibrations of the printer.
This is a simple modification to the original Z-endstop that ships with the Mosaic to keep the guide rod from rotating.
This is a simple modification to the original Z-endstop that ships with the Mosaic to keep the guide rod from rotating.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
