Thingiverse
MOSFET HW-700 Case
von mike_merryguy
2
Downloads
2
Likes
0
Makes
External Mosfet HW-700 Case
Updated, larger box to be able to actually attach the mosfet, my bad on the first one!
Wasn't thinking!!!
This is remix and I could only get 3 screws in the mosfet to the case, really don't feel like fixing it as it works just fine with 3/4 screws.
3mm screws thread in easy, I opened the holes in the lid up so they slide through very easy as long as your printer is calibrated anyway!!
Holes set to line up with a 40mm rail, plan on putting in on side of my Ender 3 with the 40404, or attach it to the table or wall... whatever works!
I printed in CF PETG and used paint on support in super slicer to support the bridge, if you have good bridge settings its a 40 MM gap, your choice!
Updated, larger box to be able to actually attach the mosfet, my bad on the first one!
Wasn't thinking!!!
This is remix and I could only get 3 screws in the mosfet to the case, really don't feel like fixing it as it works just fine with 3/4 screws.
3mm screws thread in easy, I opened the holes in the lid up so they slide through very easy as long as your printer is calibrated anyway!!
Holes set to line up with a 40mm rail, plan on putting in on side of my Ender 3 with the 40404, or attach it to the table or wall... whatever works!
I printed in CF PETG and used paint on support in super slicer to support the bridge, if you have good bridge settings its a 40 MM gap, your choice!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!